Hockey Equipment Resource Center How To Lace Hockey Skates

I tried tightening my laces in every eyelet and omg, I felt like I stepped on a bear trap. Cross over the laces and run them down both sides via the loops you’ve made on both sides before tying them as you usually would tie your shoes. From beneath, tie the lace diagonally across each eyelet, then down the tongue and around the next eyelet on the other side.

Low-quality or old skates with a thin or compressed tongue that provides little padding. Skate for mins and you should feel the difference between your skates. Kick your heel against floor a few times to make sure your foot is all the way back to the heel. I personally don’t use the eye hook on the tongue of my skate.

Ideally, the best way to lace up your skates and tie your laces is whatever gives you the ankle support and forward flexibility you need without causing lace bite. It’s important to tie the laces on your ice skates securely to avoid accidents on the ice. To tie a bow in your laces, cross the ends of the laces over each other just like you would with an ordinary shoe.

This provides the support that you need, while providing a more pliable skate. This setup enables you to flex your ankles and knees more, which increase speed and edging capabilities. Place one device where your lace bite starts, and a second device thigh knife holder where your lace bite ends. Eliminates lace bite by setting the lace tension to be “snug” in the mid-section of your skate and eliminates the need to overtighten your skates. Jack from Hockey Alley demonstrates the best way to keep ice skates tight.

The disadvantage to waxed laces is their tendency to snap, but these laces are still more durable and will typically last longer. The length of the lace corresponds loosely with the skate size that a player wears. Players with youth skate sizes should wear lace lengths from 72”-84”.

New players should beware of using this method, as it can leave players feeling unstable and can lead to ankle injuries if you’re not careful. Starting near the toe, put your thumbs on each side of the skate beside the eyelet you are going to tighten – this will create leverage so you can pull the laces tight. Use your forefinger and middle fingers to grab the lace and pull downwards.

Good lacing will firmly support a player’s feet while allowing the player to comfortably roll his or her ankles and skates inward and outward without restriction. Once your skates have been laced up well according to your own personal preferences, it is a good idea to learn how to tie them properly. You want to tighten the skate at each eyelet by pulling it tighter to get an optimal fit. If you have struggled with lacing your skates in the past, or are just getting into hockey, I’m here to help. This guide is going to take a look at how to lace hockey skates, as well as how to choose your laces and how tight your skates should be. Loosen your laces.The key to avoiding lace bite may be as simple as not tying your skates as tight, especially at the top.

Similar Posts